# Shutdown buttons and screen The tested Mi 8 Lite uses **Power + Volume Up** for an orderly Linux shutdown. The OpenRC service `platina-power-chord` is enabled in newly built images. 1. Disconnect USB/the charger so the phone runs on its battery. 2. Hold Power and Volume Up together for at least three seconds. 3. Release both buttons. The Platina logo, version and Power off screen appear while Linux shuts down. On battery, the tested phone stays off. With USB power attached, shutdown still runs, but the bootloader starts the phone again in charger mode and Linux boots normally. This is an accepted limitation. Reconnecting a charger can also start the phone. There is no automatic waiting for cable removal and no separate charging-only operating mode. The service uses both evdev inputs. Short combinations, individual keys, repeats and lost input events do not request shutdown. It acts only after both keys have been released. This requires a running kernel and userspace service; it is not an independent emergency power cut for a frozen phone. Existing long-Power reset and bootloader key combinations are unchanged. The screen indicates shutdown is in progress. Physical darkness alone is not proof that the phone is fully off. The shutdown behavior was physically verified in 0.3.0; the 0.3.1 in-place update passed screen-preview and restart checks with the same button policy. Fresh full-image packaging is audited separately. For diagnosis on a phone running a newly built 0.3.1 image: ```sh rc-service platina-power-chord status sudo platina-poweroff --preview sudo python3 /usr/local/libexec/platina-image-runtime audit ``` Preview only shows the screen for five seconds. The audit reads installed files and checksums without accessing display/input hardware or requesting shutdown. The image runtime contains no experimental PMIC module or PMIC autoload rule.