Files
2026-11-18 01:39:26 +09:00

2.9 KiB
Raw Permalink Blame History

Power buttons, status screen, offline charger and standby

The Mi 8 Lite (platina) supports lightweight server power management via platina-power-chord and platina-status-screen using the physical PMIC power button (pm8941_pwrkey), along with the legacy Power + Volume Up chord.

Button controls (power_key_mode=yes)

  1. Short-press Power (< 3s): Restores full CPU frequencies (2.21 GHz / 1.84 GHz), wakes the Tianma 1080×2280 panel (FBIOBLANK=0), and renders a live OLED status dashboard (clock, uptime, battery %/voltage/temp and 80% guard status, 4G LTE carrier/signal/IP, Wi-Fi/USB/EasyTier routes, CPU clock limits, load, and RAM usage). Refreshes every 2s and auto-blanks to FB_BLANK_POWERDOWN after 12s, or immediately on a second short press.
  2. Hold Power >= 3s (fires right at 3s, below the PMIC hard-reset timer):
    • On battery (online == 0): Shows the Power off screen for 3s and runs /usr/local/sbin/platina-poweroff --force -> /usr/sbin/poweroff.
    • With external charger/USB attached (online == 1): Enters Offline Charger Mode (brings down cellular data, blanks display, clamps all CPU clusters to 300 MHz, and keeps the 50–80% battery guard active).
  3. Offline Charger Mode (also entered automatically on boot when /proc/cmdline contains androidboot.mode=charger or androidboot.bootreason=usb_chg):
    • Short-press Power: Shows the large battery charging percentage screen for 5s, then turns the panel off.
    • Unplug external power: Automatically powers off cleanly via /usr/sbin/poweroff.
    • Hold Power >= 3s: Restores CPU clocks, exits charger mode into normal server operation, and starts platina-cellular --auto.

Crash-free runtime DVFS + panel-powerdown standby

On mainline kernel 7.2.12-sdm660, system-wide kernel s2idle (freeze) causes WCN3990 (ath10k_snoc) wlan_process fatal crashes, post-SSR MPSS ipa_bam.c assertions (dropping 4G), and mdss_ahb_clk warnings on resume. Therefore /etc/local.d/disable-suspend.start keeps /sys/power/state locked (chmod 000) while platina-power-chord implements crash-free runtime standby using hardware cpuidle (pwr-power-collapse), panel powerdown (FB_BLANK_POWERDOWN, fb0/blank=4), modem RRC_IDLE, and cluster DVFS clamping after idle_suspend_seconds (60s default):

  • Big cluster (policy0): clamped to 300 MHz (scaling_min_freq)
  • Little cluster (policy1): clamped to 633.6 MHz
  • 4G LTE, Wi-Fi, EasyTier, and SSH remain online with zero baseband resets and restore full 2.21 GHz / 1.84 GHz immediately when the Power key is tapped.

Diagnostics

rc-service platina-power-chord status
sudo platina-status-screen --json
sudo platina-status-screen --once --seconds 5
sudo platina-poweroff --preview
sudo python3 /usr/local/libexec/platina-image-runtime audit